Timing Belt--DOUBLE SIDED TIMING BELT--china manufacturer of Timing Belt

Industrial Timing Belt
DOUBLE SIDED TIMING BELT

v belts,china v-belts manufacturer,china timing belts,wrapping v belts,raw edge v belts,agricultural v belts,automtive v belt,china synchronour belts

1. The pitch&tooth type of double sided timing belt is same as synchronous belt.

                              2. There are two kinds of double sided timing belt:
                                  DA type: Arrangement symmetrical ( see section a)
                                  DB type: Arrangement overlapping ( see section b)

Note: we can produce symmetrical (DA) & overlapping (DB) two kinds double sided timing belt,
for particular specification, we can also make according to clients' drawing or sample.

pitch code	high
pitch code	mm	in
D-MXL	1.53	0.06
D-XL	3.05	0.12
D-L	4.58	0.18
D-H	5.95	0.234
D-XH	15.49	0.61
D-XXH	22.11	0.87
D-T2.5	2	0.08
D-T5	3.40	0.134
D-T10	7.0	0.275
D-T20	13.0	0.512
HTD.DA-8M	8.17	0.

Notice of keeping and installing.

                            1. Don't crimp when carrying, otherwise the tension element will buckle allowed min bend
                               diameter.(See table 1)
                            2. Don't put belt long in abnormal state. ( See table 1)
                            3. Please put the belt in dry place and avoid the scorching of the sun.
                            4. Please shorten central distance and loosen tension pulley when installing. Don't force the belt in.
                            5. Teeth with wheel should be 90?angle to belt running direction.
                            6. The parallel rate of driving gear and passive gear should be about tangent = 1/1000.
                                Inaccurateness will influence its life of use.
                            7. If belt of driving gear deviates, please adjust it and wheel's pressure.
                            8. With it drives, central distance changes and belt loosen. Please check whether belt loosen or not and
                                adjust the axle.
                            9. Timing belt should be installed as different type and width of belt.
                           10.Tension pulley should be installed on side of transmission belt.

type	pitch type	D(mm)
T type synchronous belt	MXL，T2.5	15
	XL，T5	15
	AT5，L，T10	20
	AT10，H	40
	XH，T20	70
	XXH，20M	100
Arc tooth synchronous beltf	S2M，S3M，3M，RP2M，RP3M	15
	S4.5M，S5M，5M，RP5M	25
	S8M，8M，RP8M	40
	S14M，14M，RP14M	80

V belts Timing belts belts catalog
home

home chains sprockets coulpings pulleys belts gearbox and reducers shaft collar gear&rack motor motor base universal joints

specialist in: China chains, Chain Sprocket, Speed reducer, Chain Couplings, transmission belt, spiral bevel gears